汉高电子材料市场汉高电子材料市场汉高电子材料市场汉高电子材料市场汉高电子材料市场汉高电子材料市场汉高电子材料市场

PRODUCT DESCRIPTION LOCTITE EDAG 6038SS E&C provides the following product characteristics: Technology Thermoplastic Appearance Silver Filler Type Silver, Silver chloride blend Silver : Silver chloride Ratio 9 : 1 Cure Hot air drying Operating Temperature - Continuous 100°C Product Benefits ● Applicable with manual and semi-automatic ● Compatible for use with Polycarbonate and polyester sheet and film ● Non-critical, flexible low temperature drying cycles ● Good flexibility Application Conductive Ink Typical Medical Device Application ECG disposable electrodes and Bio medical sensors LOCTITE EDAG 6038SS E&C conductive, screen printable ink consist of very finely divided silver and silver chloride particles in a blend of thermoplastic resins. It is specially designed for use as an electrode material in bio medical sensing devices. TYPICAL PROPERTIES OF UNCURED MATERIAL Solids Content, % 66 Viscosity, Brookfield , 20 °C, mPa·s (cP): Speed 20 rpm 20,000 Density, Kg/m3 1,970 Shelf Life @ 8 to 28°C, days (from date of qualification in original seal) 365 Coverage , m2/kg: Wet product @ 10 μm dry coating thickness 17 Flash Point , oC 62 TYPICAL SCREEN PRINTING PROCESS ? Printing Equipment Type Manual Semi-automatic ? Recommended Screen Type Monofilament polyester screen, threads/cm 68 to 110 ? Recommended Squeegee Polyurethane , durometer 70 to 75 ? Emulsion Thickness Emulsion Thickness , μm 20 to 40 ? Applied Dry Coating Thickness Applied Dry Coating Thickness, μm 7 to 12 TYPICAL DRYING CYCLE Recommended Drying Cycle Conventional Air Circulated Oven: 30 minutes @ 80°C or 15 minutes @ 95°C or 15minutes @ 120°C LOCTITE EDAG 6038SS E&C can be dried immediately, after printing, at temperatures between 70 to 120oC. Use jet air and infra-red drying for high speed production. The above drying profile is a guideline recommendation. Conditions (time and temperature) may vary based on customers' experience and their application requirements, as well as customer drying equipment, oven loading and actual oven temperatures. TYPICAL PROPERTIES OF CURED MATERIAL Dry Coating on polycarbonate film dried 15 minutes @ 120oC Physical Properties Adhesion, ASTM 3359, grade 5B Electrical Properties Sheet Resistance@ 25μm dry coating thickness, ohms/sq ≤0.04 GENERAL INFORMATION For safe handling information on this product, consult the Safety Data Sheet, (SDS). DIRECTIONS FOR USE 1. LOCTITE EDAG 6038SS E&C is supplied ready for use and does not require dilution. 2. Stir LOCTITE EDAG 6038SS E&C prior to each use. 3. Avoid rapid stirring as this causes air entrapment. 4. If dilution is necessary, use Arcosolv PM-Acetate, (1 to 2% by weight). 5. If a gel structure forms after extended storage, the product may be warmed slightly in a water bath (not exceeding 50oC) and stirred. CLEAN-UP 1. The equipment can be cleaned with MEK, MIBK, Acetone or similar solvents. STORAGE: Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling. Store in a cool, well ventilated area